So my WF-803M does not work right out of the box. Connected Coaxial Cable -> WF-803M -> Ethernet -> PC, and Ethernet doesn't work. I have Verizon Internet (300 mbps up/down). I found this YouTube Video (https://www.youtube.com/watch?v=zHvnbgIXf_8) since it goes much more depth on setup, but it didn't work for me either. Here are the steps I performed:
1. Plugged Ethernet from goCoax into PC. No Ethernet Internet Connection, so forced to use WiFi for Troubleshooting.
2. Changed my PC's IP assignment "Automatic (DHCP)" to "Manual" with the following settings:
IPv4 Address: 192.168.254.1
IPv4 subnet prefix length: 24
IPv4 gateway: 10.1.2.1
3. Go to http://192.168.254.254 and login. I'm into the MoCA Setup.
4. Went to "Device Settings" and changed IP Address from "192.168.254.254" to "192.168.0.199". Click "Save" and "Reboot". I also noted the MAC Address in MoCA Settings.
5. Attempted to go to http://192.168.0.199, but "Connection timeout".
6. Connected to my Router via my WiFi. On the Router, went to "Address Reservation" and added the MoCA MAC Address to the Reserved IP Address of "192.168.0.199".
7. Attempted to go to http://192.168.0.199, but "Connection timeout".
8. Changed my PC's IP assignment "Manual" to "Automatic (DHCP)".
9. Attempted to go to http://192.168.0.199, but "Connection timeout".
Ethernet still shows as "Unidentified Connection" with "No Internet" and doesn't work, only WiFi. I should also mention my Local IP Range on my Router goes from 192.168.0.100 to 192.168.0.201, and a Default Gateway of 192.168.0.1.
Any idea what I'm doing wrong here guys?
At Step 4, did you make sure to change the subnet mask and the default gateway? Make sure the subnet mask is the same as your router and then make sure that the gateway would be the IP of your router (192.168.0.1).